Featured
Official DistributorSKU
MPN
AXL SE DO16/1
Series AXL-SE-DO
AXL SE DO16/1 - Digital module
Axioline Smart Elements, Digital output module, Digital outputs: 16, 24 V DC, 500 mA, connection technology: 1-conductor, degree of protection: IP20
- 16 digital outputs
- 24 V DC, 500 mA
- Connection of actuators in 1-conductor technology
- Substitute value behavior of the outputs can be parameterized for the Smart Element
- Device rating plate stored
Technical Specifications
Dimensions
| Width | 14.9 mm |
| Height | 62.2 mm |
| Depth | 62 mm |
Utilization restriction
| EMC note | EMC: class A product, see manufacturer's declaration in the download area |
Smart Element interface
| Number of interfaces | 1 |
| Connection Method | Card edge connector |
| Transmission Speed | See system in which you use the Smart Element. |
| Start time until ready to operate | < 500 ms |
Module
| ID code (hex) | none |
| Process data channel | 16 bit |
| Input address area | 0 Byte |
| Output address area | 2 Byte |
| Required parameter data | 9 Byte |
| Required configuration data | 6 Byte |
Digital:
| Output name | Digital outputs |
| Connection Method | Push-in connection |
| Connection technology | 1-conductor |
| Number of Outputs | 16 |
| Protective circuit | Short-circuit and overload protection; electronic |
| Output Voltage | 24 V |
| Limitation of the voltage induced on circuit interruption | -32.8 V DC ... -15 V DC |
| Maximum Output Current per module | 6 A (Also make sure that the maximum permissible current of 6 A is not exceeded.) |
| Nominal Output Voltage | 24 V DC |
| Load min. | 10 kΩ |
| Output voltage when switched off | max. 1 V |
| Output current when switched off | max. 300 µA |
| Nominal load, inductive | 12 VA (1.2 H, 48 Ω, with nominal voltage) |
| Nominal load, lamp | 12 W (at nominal voltage) |
| Nominal load, ohmic | 12 W (48 Ω, with nominal voltage) |
| Switching frequency | max. 1200 per second (With resistive load, at least 50 mA load current) |
| Switching frequency | max. 1 per second (with inductive load) |
| Switching frequency | max. 16 per second (with nominal lamp load) |
| Reverse voltage resistance to short pulses | limited protection up to 0.5 A for 1 s |
| Behavior with overload | Shutdown with automatic restart |
| Behavior with inductive overload | Output can be destroyed |
| Signal delay | max. 100 µs (when switched on) |
| Signal delay | max. 100 µs (when switched off, with at least 50 mA load current) |
| Overcurrent shut-down | min. 0.7 A |
| Output current with ground connection interrupt when switched off | < 1 mA |
Product properties
| Product family | Axioline Smart Elements |
| Type | modular |
| Mounting Position | See the system in which the Smart Element is used. |
Insulation characteristics
| Overvoltage category | II (IEC 60664-1, EN 60664-1) |
| Pollution degree | 2 (IEC 60664-1, EN 60664-1) |
Electrical properties
| Maximum power dissipation for nominal condition | 1.2 W |
Potentials: Communications power supply of the Smart Elements (USE)
| Supply Voltage | using card edge connectors |
Potentials: I/O supply (UP)
| Supply Voltage | 24 V DC (using card edge connectors) |
| Supply Voltage Range | 19.2 V DC ... 30 V DC (including all tolerances, including ripple) |
| Current draw | max. 6 A |
| Current consumption | min. 40 mA (without connected peripherals) |
| Power consumption | max. 180 W (of which 1.1 W internal losses) |
| Power consumption | min. 288 mW |
| Protective circuit | Surge protection; See the system in which the Smart Element is used. |
| Protective circuit | Reverse polarity protection; parallel diode |
Electrical isolation/isolation of the voltage ranges
| Test voltage: Communications supply / 24 V supply (I/O) | 500 V AC, 50 Hz, 1 min. |
| Test voltage: Communications supply / functional ground | 500 V AC, 50 Hz, 1 min. |
| Test voltage: 24 V supply (I/O) / functional ground | 500 V AC, 50 Hz, 1 min. |
Connection technology
| Connection name | I/O |
| Note on the connection method | Please observe the information provided on conductor cross sections in the “Axioline Smart Elements” user manual. |
| Note on the connection method | With a small conductor cross section and high current, the terminal point temperature can reach up to 45 K above the ambient temperature. |
| Note on the connection method | When selecting the cables, observe the permissible operating temperature in accordance with IEC or UL. |
Conductor connection
| Connection Method | Push-in connection |
| Conductor cross section rigid | 0.25 mm² ... 1.5 mm² |
| Conductor cross section flexible | 0.25 mm² ... 1.5 mm² |
| Conductor cross section AWG | 24 ... 16 |
| Conductor cross section flexible, with ferrule without plastic sleeve | 0.25 mm² ... 1.5 mm² |
| Conductor cross section, flexible, with ferrule, with plastic sleeve | 0.25 mm² ... 1.5 mm² |
| Stripping length | 8 mm |
I/O
| Connection Method | Push-in connection |
| Note on the connection method | Please observe the information provided on conductor cross sections in the “Axioline Smart Elements” user manual. |
| Note on the connection method | With a small conductor cross section and high current, the terminal point temperature can reach up to 45 K above the ambient temperature. |
| Note on the connection method | When selecting the cables, observe the permissible operating temperature in accordance with IEC or UL. |
| Conductor cross section, rigid | 0.25 mm² ... 1.5 mm² |
| Conductor cross section, flexible | 0.25 mm² ... 1.5 mm² |
| Conductor cross section AWG | 24 ... 16 |
| Conductor cross section, flexible, with ferrule, with plastic sleeve | 0.25 mm² ... 1.5 mm² |
| Conductor cross section flexible, with ferrule without plastic sleeve | 0.25 mm² ... 1.5 mm² |
| Stripping length | 8 mm |
Ambient conditions
| Ambient Temperature (Operation) | -25 °C ... 60 °C |
| Degree of Protection | IP20 |
| Air pressure (operation) | 70 kPa ... 106 kPa (up to 3000 m above sea level) |
| Air pressure (storage/transport) | 70 kPa ... 106 kPa (up to 3000 m above sea level) |
| Ambient temperature (storage/transport) | -40 °C ... 85 °C |
| Permissible humidity (operation) | 5 % ... 95 % (non-condensing) |
| Permissible humidity (storage/transport) | 5 % ... 95 % (non-condensing) |
Standards and Regulations
| Protection class | III (IEC 61140, EN 61140, VDE 0140-1) |
Mounting
| Mounting Type | Smart Element slot |
| Mounting Position | See the system in which the Smart Element is used. |
Accessories
1088135 - Axioline F, Backplane, 4 slots for Axioline Smart Elements, transmission speed in the local bus: 100 Mbps, degree of protection: IP20
1088136 - Axioline F, Backplane, 6 slots for Axioline Smart Elements, transmission speed in the local bus: 100 Mbps, degree of protection: IP20
1212034 - Crimping pliers, for ferrules without insulating collar according to DIN 46228 Part 1 and ferrules with insulating collar according to DIN 46228 Part 4, 0.25 mm2 ... 6.0 mm2, lateral entry, trapezoidal crimp
1031721 - Crimping pliers, contact connection type: Insulated and uninsulated ferrules, standards/specifications: DIN 46228-1, DIN 46228-4, UL 486F, form A, E, F, min. cross section: 0.14 mm2, max. cross section: 10 mm2, for TWIN ferrules up to 2 x 4 mm2, automatic cross section adjustment, rotating die, lateral and frontal insertion, compression: Trapezoidal crimp, black/green
1134913 - Crimping pliers, contact connection type: Insulated and uninsulated ferrules, standards/specifications: DIN 46228-1, DIN 46228-4, min. cross section: 0.14 mm2, max. cross section: 10 mm2, For TWIN ferrules up to 2 x 4 mm2, automatic cross section adjustment, frontal insertion, compression: Trapezoidal crimp, black
Câble rond pré-équipé; automate: Axioline Realtime I/O; raccordement 1 : Fils individuels (8-pôles) (Les fils sont repérés et équipés d'embouts); raccordement 2 : IDC/FLK connecteur femelle (1x 14-pôles, 90 °-sortie); longueur de câble: 3 m
Why Proax for Phoenix Contact 1088129?
Proax is an authorized distributor of Phoenix Contact 1088129 and one of Phoenix Contact's largest distributors in North America. Our highly skilled in-house technical team is ready to assist with any technical needs.
Have a question in mind? to help you get the right product as quickly as possible for your project. We're always here to help!
Short Lead Time
Highly Trained Staff
Live Chat
Technical Support
Local Inventory
60+ Years Experience
Additional Information
| Pack Size | 1 |
Recommended
Axioline Smart Elements, Module de sortie numérique, Sorties TOR: 16 (NPN), 24 V DC, 500 mA, connectique: 1 fil, indice de protection: IP20
1181790 - Axioline Smart Elements, Digital output module, Digital outputs: 4, 24 V DC, 2 A, connection technology: 2-conductor, degree of protection: IP20
1088127 - Axioline Smart Elements, Digital input module, Digital inputs: 16, 24 V DC, connection technology: 1-conductor, degree of protection: IP20
Axioline Smart Elements, Module d'entrée numérique, Entrées TOR: 16 (NPN), 24 V DC, connectique: 1 fil, indice de protection: IP20
Axioline Smart Elements, Module à relais, Sorties à relais: 2 (indépendant du potentiel), Contact inverseur, 220 V DC, 230 V AC, indice de protection: IP20
Axioline Smart Elements, Module fonction, Entrée de comptage: 1, Entrée de commande: 1, Entrée du sens de comptage: 1, Sortie TOR: 1, 24 V DC, 100 mA, indice de protection: IP20
1088123 - Axioline Smart Elements, Analog output module, Analog outputs: 4, 4 mA ... 20 mA, connection technology: 2-conductor, degree of protection: IP20- Axioline Smart Elements, Module de sortie analogique, Sorties analogiques: 4, 0 mA ... 20 mA, connectique: 2 fils, indice de protection: IP20
1088126 - Axioline Smart Elements, Analog output module, Analog outputs: 4, 0 V ... 10 V, connection technology: 2-conductor, degree of protection: IP20
1088062 - Axioline Smart Elements, Analog input module, Analog inputs: 4, 4 mA ... 20 mA, connection technology: 2-conductor, degree of protection: IP20- Axioline Smart Elements, Module d'entrée analogique, Entrées analogiques: 4, 0 mA ... 20 mA, connectique: 2 fils, indice de protection: IP20
1088104 - Axioline Smart Elements, Analog input module, Analog inputs: 4, 0 V ... 10 V, connection technology: 2-conductor, degree of protection: IP20
1182185 - Axioline Smart Elements, Position detection module, Incremental encoder input: 1, Asymmetrical encoder, Digital inputs: 2, 24 V DC, degree of protection: IP20
1088130 - Axioline Smart Elements, Position detection module, Incremental encoder input: 1, symmetrical encoders, in accordance with EIA-422, Digital inputs: 2, 24 V DC, degree of protection: IP20
1088132 - Axioline Smart Elements, IO-Link master, IO-Link ports Class A: 4, connection method: Push-in connection, connection technology: 3-conductor, degree of protection: IP20
1079241 - Axioline Smart Elements, Digital input module, Functional safety, PROFIsafe, only for connection to Phoenix Contact or Siemens controller, Safe digital inputs: 4 (2-channel assignment), 8 (1-channel assignment), 24 V DC, connection technology: 3-conductor, degree of protection: IP20
1079231 - Axioline Smart Elements, Digital output module, Functional safety, PROFIsafe, only for connection to Phoenix Contact or Siemens controller, Safe digital outputs: 2 (2-channel assignment), 4 (1-channel assignment), 24 V DC, 2 A, connection technology: 2-conductor, degree of protection: IP20
1181787 - Axioline Smart Elements, Communication module, interface RS-232: 1, Process data width: 20 bytes, Transparent protocol, degree of protection: IP20
1088128 - Axioline Smart Elements, Communication module, interface RS-485: 1, Process data width: 20 bytes, Transparent protocol, degree of protection: IP20
Axioline Smart Elements, Module de détermination de la température, Entrées analogiques capteurs RTD: 4 (Pt 100), connectique: 3 fils, indice de protection: IP20