
2968551
SKU
PHX2968551
MPN
UM-2KS50RM/32MR/SI/1/551/Z/MT
This product is Not Cancellable/Not Returnable
Series UM
UM-2KS50RM/32MR/SI/1/551/Z/MT - Active module
VARIOFACE output module, 32 channels for Yokogawa ADV 551, ADV 561 output modules.
Technical Specifications
Product properties
| No. of channels | 32 |
| Operating mode | 100% operating factor |
| Mechanical service life | approx. 2x 10⁷ cycles |
Insulation characteristics
| Insulation | Basic insulation |
Insulation characteristics: Air clearances and creepage distances between the power circuits
| Insulation | Basic insulation |
| Overvoltage category | III |
| Pollution degree | 2 |
Air clearances and creepage distances between the power circuits
| Rated Insulation Voltage | 250 V AC |
| Rated surge voltage | 4 kV (Safe isolation, reinforced insulation, and 6 kV between input circuit and output contact current paths) |
Supported controller YOKOGAWA CS3000 CentumVP
| Suitable I/O card | ADV551 |
| Suitable I/O card | ADV561 |
Supported controller YOKOGAWA STARDOM
| Suitable I/O card | NFDV551 |
| Suitable I/O card | NFDV561 |
Input data
| Nominal input voltage UN | 24 V DC ±10 % |
| Input voltage range in reference to UN | 0.9 ... 1.1 |
| Input voltage range | 21.6 V DC ... 26.4 V DC |
| Typical input current at UN | 9 mA (K1 – K32) |
| Typical response time | 5 ms (K1 – K32) |
| Typical response time | 5 ms (K33) |
| Typical release time | 7 ms (K1 – K32) |
| Typical release time | 5 ms (K33) |
| Operating voltage display | Green LED |
Switching
| Contact switching type | 1 changeover contact |
| Type of switch contact | Single contact |
| Contact Material | AgSnO2 |
| Maximum Switching Voltage | 250 V AC/DC |
| Minimum Switching Voltage | 12 V AC/DC |
| Limiting Continuous Current | 2.8 A (observe derating) |
| Min. switching current | 10 mA |
| Interrupting rating (ohmic load) max. | 67 W (24 V DC) |
| Interrupting rating (ohmic load) max. | 20 W (48 V DC) |
| Interrupting rating (ohmic load) max. | 18 W (60 V DC) |
| Interrupting rating (ohmic load) max. | 23 W (110 V DC) |
| Interrupting rating (ohmic load) max. | 40 W (220 V DC) |
| Interrupting rating (ohmic load) max. | 700 VA (250 V AC) |
| Output fuse | 4 A (per channel) |
Field level
| Connection Method | Spring-cage connection with disconnect knife |
| Number of Connections | 1 |
| Conductor cross section rigid | 0.2 mm² ... 4 mm² |
| Conductor cross section flexible | 0.2 mm² ... 2.5 mm² |
| Conductor cross section AWG | 24 ... 12 |
Controller level
| Connection Method | Yokogawa KS-compatible |
| Number of Connections | 2 |
| Number of Positions | 50 |
| Note | Usable system cables: Phoenix Contact YUC50, Yokogawa AKB331 |
| Tightening torque | 0.5 Nm |
Signaling
| Status display present | Yes |
Dimensions
| Width | 419.5 mm |
| Height | 127.5 mm |
| Depth | 57 mm |
Ambient conditions
| Degree of Protection | IP00 |
| Degree of protection (Installation location) | ≥ IP54 (Installation location) |
| Ambient Temperature (Operation) | -15 °C ... 50 °C |
| Ambient temperature (storage/transport) | -20 °C ... 70 °C |
| Altitude | ≤ 2000 m |
Air clearances and creepage distances between the power circuits
| Standards/regulations | DIN EN 50178 |
Mounting
| Mounting Type | DIN rail mounting |
| Assembly instructions | in rows with zero spacing |
| Mounting Position | any |
Notes
| Notes on operation | Do not connect adjacent channels to SELV/ PELV and voltages dangerous to the touch. |
| Notes on operation | No additional touch protection is required when using a SELV/PELV voltage (≤ 25 V AC or 60 V DC). |
| Notes on operation | At least one functional insulation against adjacent modules is complied with (in the support rail direction). If the application has stricter requirements for the insulation (basic insulation or reinforced insulation), they must be realized by applying suitable measures (e. g. partition plates). |
| Notes on operation | For proper use, the specifications of the installation directive (see Downloads) must be observed. For applications or use with third-party products, the specifications, and the safety and warning instructions of the respective third-party manufacturer must also be met. |
Accessories
Why Proax for Phoenix Contact 2968551?
Proax is an authorized distributor of Phoenix Contact 2968551 and one of Phoenix Contact's largest distributors in North America. Our highly skilled in-house technical team is ready to assist with any technical needs.
Have a question in mind? to help you get the right product as quickly as possible for your project. We're always here to help!
Short Lead Time
Highly Trained Staff
Live Chat
Technical Support
Local Inventory
60+ Years Experience
Additional Information
| Pack Size | 2 |
Recommended



















