Enclosure Accessories

SZ Self-adhesive foam cable clamp strip, L: 3000 mm

SZ Angle bracket, for quick fastening, of PS punched rail 23x23 mm

Cable duct for TS IT enclosures that are 80" (2000mm) high and 28" (700mm) or 32" (800mm) wide.

For mounting wallmount enclosures to the floor in accordance with floormount standards. Carbon steel, 12ga, RAL 7035.

TS Partial mounting plate, for TS, SE, W/DH: 500x775 mm

TS Assembly block

TS Mounting plate attachment, installation: side with mountingplate infill, in the penultimate position/set forward

TS Side panel, for topmounting module, HD: 200x600 mm

SV Roof plate, WD: 600x600 mm, IP 2X, for TS, H: 72 mm, with ventilation hole

Designed to support components from underneath.

Floor stand kit for SE8 / TS8 enclosures. Material carbon steel, stainless steel 304, or stainless steel 316L.

SZ TS punched section with mounting flange, 23 x 73 mm, for TS, SE, for W/D: 800 mm

SZ TS punched section without mounting flange, 23 x 73 mm, for TS, SE, for WHD: 1200 mm, L: 1095 mm

PS Utility lectern, for TS, SE, CM, PC, for door width 600 mm

TS support strip, for VX, TS, VX SE, TP, for outer mounting level: for W/W: 800 mm, L: 740 mm

DK Earth rail, vertical, L: 1745 mm, For H: 2000 mm, For TS

DK-TS8 180° hinge, For sheet steel doors, TS, TS IT

Base/Plinth components, front and rear, stainless steel 316, 200 mm. Notched for TS 8 freestanding, stainless steel 316.

For mounting between the base/plinth components. Base/plinth trims may be installed rotated through 90° in order to stabilise bayed base/plinth components.

WK0905C WINDOW KIT