Drilling & Tapping Equipment

Twin spindle head for a SFB pneumatic selfeeder.

Selffeeder, 3600 rpm, 80 mm stroke,ER20 collet spindle 3/4 hp Less Motor

Selffeeder, 4500 rpm, 80 mm stroke,ER20 Collet spindle 3/4 hp Less Motor

Selffeeder, 2600 rpm, 80 mm stroke, Collet spindle, 1/2hp 480 volt

SELFEEDER, 100m stroke, 1HP 230/460V Motor, 2400rpm

ES4P-2-1330UV4

ES3P 80mm stroke with JT33 spindle, viton seals, and Air purge on body. 3/4HP 460Vac motor

SYNCHRO TAPPER STC-P316U-250-P0.8

Selfeeder Varimec, without servo motor and controls, only spindle motor and inverter included, for ER40 collet

SELFEEDER 80MM, without motor, JT______

Selfeeder 900 rpm special 6 pole motor, collet spindle

Selfeeder, 2300 rpm, 100mm stroke, 1.5 hp, 575 volt 3/4 ASA spindle

Selfeeder 900 rpm special 6 pole motor, collet spindle with purge, with body purge

Selffeeder w/gearbox, 420 rpm, 150mm stroke, 1/2hp 575 volt Drill chuck

Controller for four(4) units, I/O unit, PNP specification, Analog unit

FX5 Controller for one(1) unit, I/O unit, PNP specification, Analog unit.

VARIMEC, 1.33HP SPINDLE MOTOR, 1.6HP FEED MOTOR, 230VAC w/Brake

Servo Driven Drilling Unit with programmable feed, linear motion, and spindle speed from 250-1750 rpm, Mitsubishi control package and servo feed motor, 5.91 in. total stroke, 120 pound unit, 4600 N of thrust, 200-240 VAC servo motor/amplifier, 200V spindl

Sugino Fixed center twin head

Selffeeder, 2200 rpm, 80 mm stroke, 3/4 hp 575 volt