Base Plinth for Enclosures

For mounting between the base/plinth components. Base/plinth trims may be installed rotated through 90° in order to stabilise bayed base/plinth components.

DK base/plinth for FlatBox, W x D: 700 x 700 mm, RAL 7035

Base/Plinth components, front and rear, stainless steel 316, 200 mm.

AE Base/plinth, complete, for AE, for WD: 1000x300 mm, H: 100 mm, Sheet steel

AE Base/plinth, complete, for AE, for WD: 1000x300 mm, H: 200 mm, Sheet steel

AE Base/plinth, complete, for AE, for WD: 600x300 mm, H: 100 mm, Sheet steel

AE Base/plinth, complete, for AE, for WD: 800x300 mm, H: 100 mm, Sheet steel

SZ Fastening bolts for TS base/plinth, , plinth, complete and plinth, stationary

AE Base/plinth, complete, for AE, for WD: 600x300 mm, H: 200 mm, Sheet steel

AE Base/plinth, complete, for AE, for WD: 800x300 mm, H: 200 mm, Sheet steel

SO Levelling foot, for TS, base/plinth complete, thread M12, stainless steel 1.4301

SZ Levelling component, for H: 100 mm

SZ Levelling component, for H: 200 mm

TS Side panel, for cable chamber, for D: 600 mm

TS Cable chamber, for TS, SE, H: 200 mm, for WD: 800x600 mm

To mount between the base/plinth components. For height 200 mm, two 100 mm base/plinth trim panels can be used.

TS Trim panel, sides, H: 100 mm, for W: 1000 mm, RAL 7035, sheet steel

TS Trim panel, sides, H: 100 mm, for W: 1200 mm, RAL 7035, sheet steel

To mount between the base/plinth components. For height 200 mm, two 100 mm base/plinth trim panels can be used.

TS Trim panel, sides, H: 100 mm, for W: 300 mm, RAL 7022, sheet steel