Base Plinth for Enclosures

Floor stand kit for SE8 / TS8 enclosures. Material carbon steel, stainless steel 304, or stainless steel 316L.

VX Base/plinth corner piece, with base/plinth trim panel, front and rear, H: 100 mm, for W: 850 mm, sheet steel

VX Base/plinth trim panel, side, H: 200 mm, for D: 800 mm, sheet steel

VX Baying cover, for base/plinth system VX, sheet steel, for H: 100 mm

DK Filter mat, for base/plinth component, vented, for base/plinth component, vented with designer cover, To cover the trim panel in the base/plinth component, for width: 800 mm

Base/Plinth component consisting of one trim panel and two pre-assembled corner pieces.

TP Base/plinth, complete, for one-piece console, WHD: 600x100x400 mm, Stainless steel 1.4301

For mounting wallmount enclosures to the floor in accordance with floormount standards. Carbon steel, 12ga, RAL 7035.

TS Cable chamber, for TS, SE, H: 200 mm, for WD: 1200x500 mm

Floor stand kit for SE8 / TS8 enclosures. Material carbon steel, stainless steel 304, or stainless steel 316L.

TS Cable chamber, for TS, SE, H: 200 mm, for WD: 400x500 mm

TS Side panel, for cable chamber, for D: 500 mm

TS Cable chamber, for TS, SE, H: 200 mm, for WD: 800x500 mm

TS Cable chamber, for TS, SE, H: 200 mm, for WD: 800x600 mm

TS Trim panel, sides, H: 200 mm, for W: 600 mm, Stainless steel 1.4301

TS Base/plinth component, front and rear, H: 200 mm, for W: 800 mm, Stainless steel 1.4301

For mounting wallmount enclosures to the floor in accordance with floormount standards. Carbon steel, 12ga, RAL 7035.

TS Side panel, for cable chamber, for D: 600 mm

TS Trim panel, sides, H: 100 mm, for W: 500 mm, Stainless steel 1.4301

TS Base/plinth component, front and rear, H: 100 mm, for W: 800 mm, Stainless steel 1.4301