Enclosure Accessories

With 180° hinges and swivel handle with security lock No. 3524 E, in exchange for the comfort handle. For optimal air throughput in network enclosures with a relatively high percentage of active components. Perforated surface with air inlet opening > 78%.

With 130° hinges and locking rod including comfort handle for semi-cylinder with security lock No. 3524 E. The minimal swing radius of the individual doors allows the distance between individual bayed enclosure suites to be reduced. In addition, the door perforation over a large area of the vented variant supports climate control of the equipment. Perforated surface with air inlet opening > 78%.

With 130° hinges and locking rod including comfort handle for semi-cylinder with security lock No. 3524 E. The minimal swing radius of the individual doors allows the distance between individual bayed enclosure suites to be reduced. In addition, the door perforation over a large area of the vented variant supports climate control of the equipment. Perforated surface with air inlet opening > 78%.

With 130° hinges and locking rod including comfort handle for semi-cylinder with security lock No. 3524 E. The minimal swing radius of the individual doors allows the distance between individual bayed enclosure suites to be reduced. In addition, the door perforation over a large area of the vented variant supports climate control of the equipment. Perforated surface with air inlet opening > 78%.

With 130° hinges and locking rod including comfort handle for semi-cylinder with security lock No. 3524 E. The minimal swing radius of the individual doors allows the distance between individual bayed enclosure suites to be reduced. In addition, the door perforation over a large area of the vented variant supports climate control of the equipment. Perforated surface with air inlet opening > 78%.

180° hinge for bayed TS enclosures,

Base/Plinth component consisting of one trim panel and two pre-assembled corner pieces.

TS Glazed door, for TS, TS IT, SE, for WH: 800x1800 mm

TS Base/plinth component, front and rear, H: 100 mm, for W: 1000 mm, Stainless steel 1.4301

For mounting between the base/plinth components. Base/plinth trims may be installed rotated through 90° in order to stabilise bayed base/plinth components.

DK-TS8 Roof plate, WxD: 600x600 mm, 2-part, For cable entry

To replace standard roof. 72 mm high roof plate, all-round vent slots, clamping profile for cable entry. The two-piece design with cable entry allows for easy retro-fitting.

To replace standard roof. 72 mm high roof plate, all-round vent slots, clamping profile for cable entry. The two-piece design with cable entry allows for easy retro-fitting.

To replace standard roof. 72 mm high roof plate, all-round vent slots, clamping profile for cable entry. The two-piece design with cable entry allows for easy retro-fitting.

To replace standard roof. 72 mm high roof plate, all-round vent slots, clamping profile for cable entry. The two-piece design with cable entry allows for easy retro-fitting.

To replace standard roof. 72 mm high roof plate, all-round vent slots, clamping profile for cable entry. The two-piece design with cable entry allows for easy retro-fitting.

SV Partial door, WH: 600x600 mm, for TS

TS punched section with mounting flange, 17 x 73 mm, for door width: 800 mm, L: 690 mm

SV Partial door, WH: 400x600 mm, for TS

SV Partial door, WH: 600x150 mm, for TS