Roof and Wall Mounting Solutions for Enclosures

To replace standard roof. 72 mm high roof plate, all-round vent slots, clamping profile for cable entry. The two-piece design with cable entry allows for easy retro-fitting.

To replace standard roof. 72 mm high roof plate, all-round vent slots, clamping profile for cable entry. The two-piece design with cable entry allows for easy retro-fitting.

To replace standard roof. 72 mm high roof plate, all-round vent slots, clamping profile for cable entry. The two-piece design with cable entry allows for easy retro-fitting.

To replace standard roof. 72 mm high roof plate, all-round vent slots, clamping profile for cable entry. The two-piece design with cable entry allows for easy retro-fitting.

For enclosures without roof plate and to replace the standard roof on other TS enclosures.

VX Roof plate, Wdepth 600x600 mm, for cable entry glands

SZ Dust guard trim, for VX, TS, VX SE, L: 600 mm

AX Protective roof, for WD: 800x300 mm, stainless steel

SZ spacer, for VX, TS roof plate, H: 20 mm

TS Wall bracket, sheet steel, galvanized

For enclosures without roof plate and to replace the standard roof on other TS enclosures.

For enclosures without roof plate and to replace the standard roof on other TS enclosures.

For enclosures without roof plate and to replace the standard roof on other TS enclosures.

IP 2X roof plate with ventilation hole for VX, VX IT (NCNR)

SZ Paint

SZ Paint

SZ Spray can, 150 ml, RAL 9005

PS Roof mounting screw

TS Top-mounting module, for TS, for WD: 1000x600 mm

AX Portective roof, for WD: 300x210 mm, stainless steel