Composants de distribution et de protection électrique

OTPE60FP EARTH TERMINAL

OTPL60FP Fourth pole with late-break and early make function. Mountable on the side of the switch.

OTS400G1S/4 TERMINAL SHROUD

OTS800G1S/4 TERMINAL SHROUD

Handle and spare fuse can be stored at the side of the switch with handle clamp.

OTZC54 MOUNTING PIECE 4-POLE

OTZC64 MOUNTING PIECE 4-POLE

Two switches connected with a mechanism operating into I-O-II positions. Two 3 or 4-pole switches needed, OT100…125F_.

OWP6D40 CONVERSION KIT

For switch-disconnectors with wide phase distance (140 mm or 185 mm). Supporting 12 mm shafts longer than 280 mm for OT1000...2500.

OZ331P67B PADLOCKABLE IP67 HANDLE

IP65, NEMA 4X outdoor, size 66x66, suitable for 6 mm shaft (four-hole mounting), black

3-LUG KIT,PWR DIST,800-1200A

OZXT3 TERMINAL SET

The ZLS100 is a busbar cover electrically protected covering of main and auxiliary busbars. The 4 modules cover can be divided. Suitable to accept extension adapter ZLS 101 4x18 mm – bag containing 5 items

Incoming terminal Feeder component N with 2 Modules 36mm width, 200A; 10 mm2 up to 95 mm2 max. 1 wire. For the SMISSLINE TP 125A and 250A system

The EPD24 protection devices expand ABB's product portfolio of DIN rail mounted devices with electronic overcurrent protection modules for selective protection of 24 V DC load circuits. Faults in individual branches caused by overload or short circuit are detected and selectively switched off so that other load current paths remain unaffected by the fault. In this way straightforward, quick troubleshooting is made possible.

The EPD24 protection devices expand ABB's product portfolio of DIN rail mounted devices with electronic overcurrent protection modules for selective protection of 24 V DC load circuits. Faults in individual branches caused by overload or short circuit are detected and selectively switched off so that other load current paths remain unaffected by the fault. In this way straightforward, quick troubleshooting is made possible.

The EPD24 protection devices expand ABB's product portfolio of DIN rail mounted devices with electronic overcurrent protection modules for selective protection of 24 V DC load circuits. Faults in individual branches caused by overload or short circuit are detected and selectively switched off so that other load current paths remain unaffected by the fault. In this way straightforward, quick troubleshooting is made possible.

ODPSE230C DUAL POWER SOURCE