Composants de distribution et de protection électrique

OHY65J6T PISTOL HANDLE

OHY65L10B HANDLE

OMZB28 VOLTAGE SENSING CONNECTORS R2

For mounting the OMD automatic control unit on the door. The type and ordering code is for 1 piece, so 2 units must be ordered for mounting the control on the door.

3P SW 100A J FUSE FLANGE OPER

3P SW 1200A L FUSE FLANGE CABLE

Switch Fuses,Side Operated,3-pole,03 (Left Side),Class J,200 A,Handle and shaft not included,

Switch Fuses,Front operated,4-pole,04 (Left Side),Class J,400 A,Handle and shaft not included,Switched - Fusible Pole

OS400JS30 FUSIBLE DISCONNECT SWITCH

Switch Fuses,Front Operated,3-pole,03 (Left Side),DIN,000,Handle and shaft not included,

TERM SHROUD 3P OS1200L30-FC FLANGE

3P SW 1200A NF FLANGE CABLE

4-pole, front operated, base mounted, DIN-rail mountable switch-diconnector / non-fusible diconnect switch with front protected clamp terminals, handle and shaft are not included

4-pole, front operated, base mounted non-fusible diconnect switch, handle and shaft are not included, terminal bolt kit included

Including a black plastic IP65 I-0-II pistol type handle (see the table below), shaft and bolt set for the cable connection. Handle not padlockable and no door interlocking. Operating angle 90° to achieve fast switching. Minimum OFF-time between transfer from I-II or II-I is 20 ms.

4-pole, front operated, base mounted switch-diconnector with protected clamp terminals, handle and shaft are not included

4-pole, front operated, door mounted switch-diconnector with protected clamp terminals, handle and shaft are not included

3-pole, front operated, base mounted non-fusible diconnect switch, handle and shaft are not included, terminal bolt kit included

3-pole, front operated, base mounted non-fusible diconnect switch with black IP65 handle and shaft, terminal bolt kit included

4-pole, front operated, base mounted non-fusible diconnect switch, handle and shaft are not included, terminal bolt kit included